SeaMAID multicoloured pool bulb PAR56
SeaMAID LED bulb colour TL with remote control
Easy installation in standard PAR56 alcoves ,
Powerful beam of 1450lm maximum,
Low electricity consumption,
The bulb's standard dimensions indicate the SeaMAID lamp can be installed without any particular manual work in any standard PAR56 alcove to replace a classic, 300w incandescent pool bulb.
Two models are available :
- The SeaMAID lamp, commanded from a control box
- The SeaMAID TLcommanded by remote control or supplied remote control
A PERFORMANT AND RESISTANT POOL BULB
Designed with polycarbonate injection, the SeaMAID bulb is highly resistant to shocks, heat and chemical aggression of water treatment products.
This bulb features two moulded screw terminals that ensure the waterproof aspect of the bulb and its solidity to the power supply connection.
The optic of the lamp has been studied to dispatch light in a homogeneous and visually comfortable manner throughout the pool water. The optic is soldered by friction (method used to assemble polymers) and so provides a high level of resistance.
The force of SeaMAID
SeaMAID uses a renowned, active Research & Development department that is equipped with a unique testing lab : A subaquatic measurement device designed in collaboration CSTB, Nantes, France and the National Testing Laboratory (Laboratoire National d'Essais -LNE). Using this device, SeaMAID can precisely measure the true lumen of its lighting systems in their operational environment as requested in the European regulation 1194.
The test results are incontestable and correspond to the reality of operational lighting in an aquatic environment.
|Colour temperature||Ra (CRI)||Diffusion angle||Rated Luminous Flux|
|Red 1000K||16.4||120°||112 lumens|
|Green 8000K||25.3||120°||320 lumens|
|Blue 100 000 K||46.8||120 °||80 lumens|
*CRI : Colour Rendering Index. Applicable measures for the PAR56 MULTICOLOUR sold with or without remote control.
AN ECONOMIC POOL BULB
A luminous source powered by LED represents a substantial economy : SeaMAID LED bulbs use 20 times less power and have a lifespan 50 times superior to a classic incandescent bulb.
To install you SeaMAID bulb, just fit a 2 x 1,5mm² cable section to a toroidal transformer with a 20w protection.
SeaMAID CE pool lamp commanded by control box
SeaMAID TL pool lamp commanded by remote control
* The lifespan is an indication based on information supplied by the manufacturer. This indication is in no way contractual and can vary depending on the frequence of use and varying, fluctuating electrical currents.
The SeaMAID CE multicoloured lamp can be commanded by the optional SeaMAID radio control module.
The capacity of the transformer
The transformer on which you connect your SeaMAID LED bulb must have 12V tension.
The capacity of the transformer must be in adequation with the power of the lighting projectors that will be connected to the transformer. Anticipate a 20% superior safety margin when calculating the power consumed by the lighting projectors.
The below table indicates the number of SeaMAID bulbs that a transformer can supply, depending on its capacity.
Installing the bulb
The pool bulb (2) can be installed in all PAR-56 standard alcoves(1) replacing an incandescent bulb. Its connection is easy and the bulb is guaranteed to be waterproof.
With low energy consumption, you can use the bulb intensively without a risk of overheating the transformer, resulting in electrical complications.
- Before all operation cut the lighting projectors power supply
- Remove the lighting block from the pool and un-secure the bulb support
- Disconnect the bulb out of the pool water
- Check waterproof seal as well as the bulb support and change if you need to
- Spread a layer of silicone on either side of the waterproof seal
- Connect the LED lamp, screw the support into place and allow the silicone to dry for 15 minutes - then replace into the projectors alcove
- Check the waterproof aspect of the support and light the lamp
Price incl. VAT
Ask for a free quote seamaid multicoloured pool bulb par56
Other product : SeaMAID multicoloured pool bulb PAR56
Starting from 154 eur Including VAT.
Please fill in this form carefully. Our commercial service will handle your request promptly.
UK freephone hotline
Monday Friday 9.00 19.00, Saturday 10.00 18.00